Hobie Forums
http://www.hobie.com/forums/

Masthead float questions
http://www.hobie.com/forums/viewtopic.php?f=23&t=67004		 Page 1 of 1
Author:  kwuog [ Wed Jul 22, 2020 9:12 am ]
Post subject:  Masthead float questions
I recently removed the masthead float from my 2011 Getaway so that I could clean it.

During cleaning I noticed two things that seemed odd:

Image

(1) The mounting bracket puts the float at angle to the mast. Is my bracket bent or is this how it's supposed to be?

(2) While cleaning the float I removed the screw-on stopper seen in the photo above and I heard the distinctive sound of air being released from the float. Was that just a function of the normal atmosphere in the float having been heated --it's July in Texas as I do this-- or did I need to do something special now to refill this float with air? (That seems unlikely, but since I was asking about point #1 I thought I would ask about this as well.)

(2a) Assuming that the answer to #2 is "No, goofy, you don't need to fill the float with air" then what is the purpose of the screw-on stopper?

Thanks! --Matt
Author:  mmiller [ Wed Jul 22, 2020 10:27 am ]
Post subject:  Re: Masthead float questions
Just heat expansion of the air. Good that is exhaled!

The bracket is bent. Should be square to the float / mast.
Author:  kwuog [ Fri Jul 24, 2020 8:54 am ]
Post subject:  Re: Masthead float questions
Quote:
The bracket is bent. Should be square to the float / mast.

Thanks, Matt. Is there a part number for just the bracket? So far I've only found a part that covers the entire assembly, which would be overkill.

Also, what is the function of the screw cap and this circular plug?

Image
Author:  mmiller [ Fri Jul 24, 2020 9:13 am ]
Post subject:  Re: Masthead float questions
Black drain plug.

The white spin-weld cap covers the rotomolding vent.
Author:  KBlake [ Fri Jul 24, 2020 1:35 pm ]
Post subject:  Re: Masthead float questions
kwuog wrote:
Quote:
The bracket is bent. Should be square to the float / mast.

Thanks, Matt. Is there a part number for just the bracket? So far I've only found a part that covers the entire assembly, which would be overkill.



Image


You can remove the brackets and bend them square again. No need to purchase new ones.
Author:  kwuog [ Fri Jul 24, 2020 2:27 pm ]
Post subject:  Re: Masthead float questions
Quote:
You can remove the brackets and bend them square again. No need to purchase new ones.

Of course, that's been my plan if there's no way to get just a replacement bracket. Since the mast head float is an important safety feature, I don't mind springing for a new mounting bracket if possible.
Author:  BRinSCupstate [ Fri Jul 24, 2020 5:49 pm ]
Post subject:  Re: Masthead float questions
They’re not bent too bad. You should be fine removing them and bending them back.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/