Return to Hobie.com
Hobie Forums
It is currently Sat Jan 23, 2021 6:58 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Tue Jan 12, 2021 10:59 am 
Offline
Site Rank - Deck Hand

Joined: Sat Jul 18, 2020 3:21 pm
Posts: 5
I have a jib sail that has no jib luff cable. It has 5 jib hanks that attach to the fore stay. Will this design work without the luff cable?


Top
 Profile  
 
PostPosted: Wed Jan 13, 2021 11:20 am 
Offline
Site Rank - Admiral

Joined: Wed Aug 08, 2007 10:20 pm
Posts: 263
Location: South Boardman, Mi
Technically possible but not recommended.

Hobie 16's use the jib halyard to tension the rig. While sailing the luff cable in the jib handles all the load that is traditionally carried by the forestay on other boats. If you were to properly tension the rig on a H16 that did not have a luff cable the jib would rip under the loads. You could try tensioning the rig using the forestay. This may require modifications to the forestay or the adjuster/chainplate. If you chose to go this route follow the instructions in the H18 manual for raising the jib. Specifically be sure to raise the main first, tension the mainsheet and then raise and tension the jib. If you raise the jib first the jib halyard will take up the slack in the rig and when you sheet in on the main you will damage your jib by overtensioning the luff.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group