Return to Hobie.com
Hobie Forums
It is currently Tue Oct 22, 2019 10:27 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: hull bottom thickness
PostPosted: Wed Jul 24, 2019 6:03 pm 
Offline
Site Rank - Deck Hand

Joined: Tue Sep 26, 2006 7:38 pm
Posts: 2
Hello: I have an older Hobie wave, and it appears that one of the hulls was replaced. The port hull was made in the late 90s, while the starboard hull is from the early 2000s. Both hulls appear to have been dragged across quite a bit of sand over the years, as they are basically flat along the bottom. I do have inspection ports in each hull, and the inside of the hull bottom appears to be solid. However, I can't tell how much plastic lies below. I would appreciate it if anyone could tell me how thick the Hobie Wave hulls are along the bottom. I am a bit worried about grinding though the next time I sail at the beach. Thanks.


Top
 Profile  
 
PostPosted: Thu Jul 25, 2019 1:51 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 13099
Location: Oceanside, California
There is an outer "Cross-Linked" polyethylene that varies in thickness, but maybe 3/16" or more. Then an inner core of foamy plastic that is pretty thick...1/4" or more as a guess.

_________________
Matt Miller
Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group