|
Site Rank - Captain |
Joined: Fri Apr 13, 2007 10:54 pm Posts: 104 Location: BC, Canada
|
You might be trying to clip each hank onto the coated portion of the wire ... and you would be right - it doesn't fit.
Make sure you have an inch or so of bare wire just above the fore stay adjuster. If not, the cut the coated portion back a bit until you do. Slide the hank in sideways over the bare wire and then twist to vertical. Once attached in that manner, it will slide up perfectly over the coated wire. You have to do that for each hank when raising the jib.
Reverse the process for each hank when removing the jib.
|
|