Hobie Forums http://www.hobie.com/forums/ |
|
Need help on Wave Spinnaker and where bungy attaches. http://www.hobie.com/forums/viewtopic.php?f=24&t=70448 |
Page 1 of 1 |
Author: | Gbrooks2003wave [ Sun Nov 27, 2022 7:51 am ] |
Post subject: | Need help on Wave Spinnaker and where bungy attaches. |
I am looking for instructions to setup a spinnaker on my Wave. I have the sail and pole (just ordered end cap that attaches to front crossbar). I am having a challenge on where the bungy from the pole attaches to. I am getting killed on down wind runs from mcscows and monos flying their spinnakers at my sailing club. Pics would be appreciated to |
Author: | mmiller [ Wed Dec 07, 2022 10:46 am ] |
Post subject: | Re: Need help on Wave Spinnaker and where bungy attaches. |
https://media.hobie.com/item_attachments/38999000z52.pdf Shock cord hooks to the bridle shackle. This pulls the pole up. Pole bridles hold it down. |
Author: | Gbrooks2003wave [ Fri Dec 16, 2022 7:28 am ] |
Post subject: | Re: Need help on Wave Spinnaker and where bungy attaches. |
Matt, thank you so much and hope you are enjoying that retirement. Merry Christmas, health and happiness and good winds in 2023. |
Author: | Gbrooks2003wave [ Mon Dec 19, 2022 4:54 pm ] |
Post subject: | Re: Need help on Wave Spinnaker and where bungy attaches. |
So with Matt’s help, I got the spinnaker pole installed. Now, does anyone know the length of the spinnaker sheet that runs continuously around the wave? 9 ft for tack line, 45 ft for spinnaker halyard, but missing length of spinnaker sheets. Thanks to all and Matt, thank you for 10 yrs I have had with your guidance and knowledge. |
Author: | hobie_sls [ Tue Dec 20, 2022 5:52 pm ] |
Post subject: | Re: Need help on Wave Spinnaker and where bungy attaches. |
The correct spinnaker sheet length for the Wave is 38ft of 6mm or 1/4in line. - Starting Line Sailing |
Author: | Gbrooks2003wave [ Wed Dec 21, 2022 6:47 am ] |
Post subject: | Re: Need help on Wave Spinnaker and where bungy attaches. |
Thanks for the information on the spin sheet length. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |