| Hobie Forums http://www.hobie.com/forums/ |
|
| Wave - mainsheet block http://www.hobie.com/forums/viewtopic.php?f=24&t=70856 |
Page 1 of 1 |
| Author: | Tim.in.MD [ Wed Jun 21, 2023 3:23 pm ] |
| Post subject: | Wave - mainsheet block |
Recently purchased a ~2018 Wave. Love it, but...I've sailed many boats big and small, and when there's a puff, I yank UP on the mainsheet to release it from the jaws of the mainsheet block. On this boat, I have to push the mainsheet DOWN to release it, which I find very difficult to do quickly. I have to use my foot to push it down, but my foot is not always in the right spot. I have the Ronstan RF40530, which I assume is the standard block and this is the normal setup. It appears there are three positions on the block - it's currently in the middle one - I'd like to change the position - that may help slightly - but I can't budge the little pin that perhaps lets me change it? Below is a link to the block. https://www.ronstan.us/marine5/product. ... No=RF40530 What am I missing here? |
|
| Author: | mmiller [ Wed Jul 12, 2023 9:56 am ] |
| Post subject: | Re: Wave - mainsheet block |
Lubricate the pin area to loosen it up. Downward release is preferred on a catamaran. Holding the mainsheet with minimal slack to the cleat, raise the sheet-hand and then snap downwards which sends a ripple down the sheet to the cleat. This if done correctly it will pop the line out of the cleat. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|