Hobie Forums http://www.hobie.com/forums/ |
|
Vertical Outback carrier http://www.hobie.com/forums/viewtopic.php?f=26&t=43802 |
Page 1 of 1 |
Author: | Jlbltd [ Wed Jul 11, 2012 1:24 pm ] |
Post subject: | Vertical Outback carrier |
I have a 24' motorhome and I want to make a carrier to fit in the 2" trailer receiver to carry my Outback. I can't put it on the roof. I would need to some angle or tilt so I wouldn't exceed the 13'6" limit. It has a ladder on the right rear(passenger side) to help fasten it to. Any ideas, suggestions or plans? No commercial units that I found for this 12' length. |
Author: | VaBeach1 [ Thu Jul 12, 2012 7:03 am ] |
Post subject: | Re: Vertical Outback carrier |
I think you would have to build this yourself. I am thinking a Hitch Extender- modified. I have been thinking about doing something similar (but for loading and unloading with ease off of a high Wrangler.) The height will be your biggest issue/tilting. I have been thinking about a "Hitch Clevis joint" as the pivot. Drill the pivot holes in the bottom of the hitch extender. You would then need to brace the angle with brackets (bolted on). I am not sure how strong this would be: Your best bet would be to take your concept over to a local welding shop and see what they can come up with. Hope this gives you some ideas. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |