Hobie Forums http://www.hobie.com/forums/ |
|
RAM Transducer Arm/Elite-4x DSI install on my Revolution 13 http://www.hobie.com/forums/viewtopic.php?f=26&t=45978 |
Page 1 of 1 |
Author: | Hanover_Yakker [ Thu Dec 13, 2012 6:20 pm ] |
Post subject: | RAM Transducer Arm/Elite-4x DSI install on my Revolution 13 |
Decided to change up my FF install a little. I opted for the RAM Transducer Arm kit and switched to a smaller profile DSI unit. The best part of the install was keeping it portable to try and prevent corrosion overtime and to facilitate moving the setup to a different kayak if need be in the future. Hope you find it helpful or at least informative on how you would not do it if it were yours http://froggin4bass.blogspot.com/2012/12/lowrance-dsi-battery-installation-pt3.html |
Author: | Elgeebee [ Sun Dec 16, 2012 7:03 am ] |
Post subject: | Re: RAM Transducer Arm/Elite-4x DSI install on my Revolution |
Nice clean install...congrats! |
Author: | defjack [ Sun Dec 16, 2012 7:09 am ] |
Post subject: | Re: RAM Transducer Arm/Elite-4x DSI install on my Revolution |
I got the same ram mont . How did you bend the shaft? Did you use a tube bender? Jack |
Author: | Hanover_Yakker [ Mon Dec 17, 2012 6:31 am ] |
Post subject: | Re: RAM Transducer Arm/Elite-4x DSI install on my Revolution |
Thanks Lewis. @jack - the aluminum shaft provided is both bendable by hand and able to trimmed to fit your specific install needs. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |