Hi everyone, I have a 2014 Oasis and plan to use it for fishing, on my own, sitting in the back seat.
I am thinking of mounting my fish finder transducer in the front drive cassette hole, by 3d printing a new cassette with a suitable cut out for the transducer.
My question is, would it be better to just make the transducer flush with the bottom of the cassette or would it be better to form a curve in the bottom of the cassette so that the transducer ends up flush with the bottom of the kayak but clear of the cassette by a few millimetres? My concerns are, flush could effect the transducer if it shoots sideways through the cassette (do they shoot sideways at all?), curved could result in turbulent water around the transducer?
