Return to

Hobie Forums

It is currently Wed Jan 17, 2018 6:44 am

All times are UTC - 8 hours [ DST ]

Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: FF on a revo
PostPosted: Wed Jan 16, 2008 11:21 am 
Site Rank - Captain

Joined: Wed Apr 04, 2007 5:44 pm
Posts: 43
Thanks to all the response to my orginal posting
Revolution fish finder mounting suggestions ?

This is my design
Hope this is helpful

Using the sail mast receptacle
However I detached the original base and crafted a double pivot base with a transducer wire pass through

None of the pieces are glued down especially the cap

Sometimes you might need to take section off to more easily pass the wire

I ran the power/tranducer wire through the sail mast receptacle. The sail mast receptacle unscrews. Although a solid piece of plastic it has a solid divider to form a 2 or 3 inch female end which is placed on the male end that is part of the interior of the hull.

One hole drilled above the divider and a pass through is formed

The whole assembly goes into the sail mast receptacle including the pass through wires

1. 1 2ft piece of 1/2 PVC
2. 1 four-way T
3. 4 90deg elbows
4. a 1/2 cap -drilled
5. 4 spare sections of 1/2 pvc l(like 2 in maybe each)
6. 4 in or so piece of 1/2 in pvc




Hobie Mirage Revolution
Ocean Kayak Prowler 13
- Look ma no hands

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group