Hobie Forums http://www.hobie.com/forums/ |
|
Oversize taper pins or epoxy the frame? http://www.hobie.com/forums/viewtopic.php?f=45&t=29961 |
Page 1 of 1 |
Author: | gary eudy [ Thu Aug 19, 2010 9:52 am ] |
Post subject: | Oversize taper pins or epoxy the frame? |
This is a question for Hobie Matt I have trailered large and wide the last few years with no problems This has cut set up and take down time in half I do need one oversize pin for sure and maybe two oversize pins What about drilling a oversize hole in the frame and placing a regular SS bolt washer and nut instead of the taper pin which is used for alignment when pulling hulls in and out I am also thinking about putting epoxy in the frame and bonding everything together I would leave the pins in place for tramp ties and added strength Any thoughts I measured my Hydra Sport 24 side to side it is 2" form Hobie 21SE side to side and I pull it thousands of miles pulling large and wide is the only way to go |
Author: | mmiller [ Thu Sep 09, 2010 3:16 pm ] |
Post subject: | Re: Oversize taper pins or epoxy the frame? |
Either or both ideas would work. |
Author: | gary eudy [ Fri Sep 10, 2010 8:21 am ] |
Post subject: | Re: Oversize taper pins or epoxy the frame? |
Hobie Matt Many Thanks I will let all know of results |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |