Hobie Forums http://www.hobie.com/forums/ |
|
Gin Pole 21SC http://www.hobie.com/forums/viewtopic.php?f=45&t=62929 |
Page 1 of 1 |
Author: | drcam1 [ Sat Jun 09, 2018 7:48 am ] |
Post subject: | Gin Pole 21SC |
I am going to make a gin pole to help solo step my mast on 21SC. Does anyone know the length? I took a rough measurement and get 80 inches. If mast was already up, I could take measurement to base of furler, but hard to eyeball angle with mast down. Any other thoughts/suggestions? Thanks! |
Author: | kevinbatchelor [ Tue Jun 12, 2018 4:11 pm ] |
Post subject: | Re: Gin Pole 21SC |
I'll see if I can remember to get mine out and measure it for you. |
Author: | mmiller [ Tue Jun 12, 2018 4:19 pm ] |
Post subject: | Re: Gin Pole 21SC |
Minimum mast to past the furler drum. Longer is better. Short and it will pull out of the mast under load. Drawing says 80" |
Author: | kevinbatchelor [ Tue Jun 12, 2018 9:30 pm ] |
Post subject: | Re: Gin Pole 21SC |
Confirmed, I measured mine at 80 inches long with a outer diameter of 1 7/8". |
Author: | drcam1 [ Wed Jun 13, 2018 5:38 am ] |
Post subject: | Re: Gin Pole 21SC |
Thanks everyone! Time to get building!!! |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |