Return to Hobie.com

Hobie Forums

It is currently Mon Jan 22, 2018 9:12 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Nov 15, 2017 2:55 pm 
Online
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 12053
Location: Oceanside, California
Quote:
Inflatable Kayaks – Maximum Pressure

It is possible to achieve damaging pressure in kayak air chambers by over inflating or storing a fully inflated kayak in high heat. High heat is also a cause of seam failures as the adhesives are compromised or weakened by over-heating.

The maximum recommended pressures are as follows:
3 psi / 0.2 bar for side chambers
6 psi / 0.4 bar for floor chambers


We recommend releasing pressure during storage and keeping the kayak in a cool environment / covered to protect from excessive heat.


Quote:
Image

This is a drain for the bilge area which is also required as a vent during inflation and deflation. This cap should be removed at all times during inflation and deflation to allow air pressure to equalize in the bilge chamber. This area is NOT to be pressurized. Concern: Pressurizing the bilge chamber can damage the scupper fittings and cause unnecessary concern about the area “leaking”. This bilge area can be drained of water by opening the cap and tipping the boat onto its bow.


Quote:
Folding technique video.

I have added several instructional video segments to our support pages about unpacking, inflating, deflating and re-packing Hobie Mirage inflatables into their travel bags.

http://www.hobiecat.com/support

Scroll down to the inflatables product section.

Video segments include:

Hobie Mirage i-9 http://www.hobiecat.com/support/mirage-i9s/

Hobie Mirage i-11 http://www.hobiecat.com/support/mirage-i11s/

Hobie Mirage i-12 http://www.hobiecat.com/support/mirage-i12s/

Hobie Mirage i-14 http://www.hobiecat.com/support/mirage-i14t/

Packing Accessories into Travel Bag (all models)


Quote:
This is the method that I use to pack up my i11S. We used this method on both of our i11S inflatables when we took them from Brisbane to Vancouver Island, BC. Drives were taken apart and transported in our regular luggage. All was good until the TSA folks in LA decided to remove the shrink wrap we added in Brisbane and unpack them. They didn't pack them back in the same way and we ended up with a big hole in the bag where the seat rubbed on the flight from LA to Seattle. I wasn't a happy camper. All in all they traveled really well in both directions.


_________________
Matt Miller
Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group