Return to Hobie.com
Hobie Forums
It is currently Mon Mar 18, 2024 7:57 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Nov 15, 2017 3:02 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 15021
Location: Oceanside, California
The screw that attaches the base of ARC cranks to the drums must be properly tensioned to hold the crank against the drum adjustment holes.
Tension the screws to add a moderate amount of friction to the fore and aft movement of the ARC cranks. A loose screw could allow the crank to move away from the adjustment holes and possibly strip the outer plastic away between adjustment holes.

Image

The ARC crank drives use a 7/32” Allen Wrench.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group