Return to Hobie.com
Hobie Forums
It is currently Wed Nov 13, 2024 3:01 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Fri May 22, 2009 5:17 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 15076
Location: Oceanside, California
A couple of things about the drive chains and possibly skipping a sprocket tooth (older Stainless sprockets):

1) If the chain skips a tooth the easy way to get the chain back on the right tooth is to press hard on the opposite pedal from which it originally slipped. Once it is on the right tooth again tighten the chain properly.

2) The proper way to tighten the chains is to make sure that the front chain is tighter than the rear. The front chain will be tighter than the rear when there is proper tension in the Idler cable (goes over the drum up front, from side to side). Any tension in the Idler cable will add tension to the front chain and reduce tension in the rear chain. Whenever the chain skips a tooth it is always the front sprocket. We suspect some people are tensioning the chains and are overlooking the Idler cable.

3) If the chain skips a tooth the drive will still work – the stroke will be shorter and unbalanced, but it will still work. We would not recommend disassembling the drive on the water.

4) The newer injection molded plastic sprocket has done a good job of eliminating the skipping problem.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group