|MirageDrive ARC Crank Assembly
|Page 1 of 1|
|Author:||mmiller [ Wed Nov 15, 2017 3:02 pm ]|
|Post subject:||MirageDrive ARC Crank Assembly|
The screw that attaches the base of ARC cranks to the drums must be properly tensioned to hold the crank against the drum adjustment holes.
Tension the screws to add a moderate amount of friction to the fore and aft movement of the ARC cranks. A loose screw could allow the crank to move away from the adjustment holes and possibly strip the outer plastic away between adjustment holes.
The ARC crank drives use a 7/32” Allen Wrench.
|Page 1 of 1||All times are UTC - 8 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group