Hobie Forums http://www.hobie.com/forums/ |
|
Better sail controls for both seats on 2015 TI http://www.hobie.com/forums/viewtopic.php?f=69&t=57471 |
Page 1 of 1 |
Author: | Chekika [ Wed Apr 27, 2016 2:14 am ] |
Post subject: | Re: Better sail controls for both seats on 2015 TI |
Nice! Keith |
Author: | jhawkman [ Sat Dec 17, 2016 2:21 pm ] |
Post subject: | Re: Better sail controls for both seats on 2015 TI |
Looks like a very practical setup. Quick question on another topic - looks like you are using the Harbor Freight trailer - how did you extend the front to accommodate the length of the TI? Thanks. |
Author: | GaryInWI [ Sun Jan 01, 2017 11:19 am ] |
Post subject: | Re: Better sail controls for both seats on 2015 TI |
Nice setup. Could you provide the specific part numbers for the cheek block, rail (length?) and dual cam cleat that you used? Was your line guide a DIY job? Also, does the rail have a backing plate inside the hull or washers & nuts? And how difficult is access to the inner hull where the rail is mounted? Thanks, Gary 2014 Tandem Island 1984 Hobie Hawk RC Glider |
Author: | LSYak [ Mon Jan 02, 2017 6:02 pm ] |
Post subject: | Re: Better sail controls for both seats on 2015 TI |
Nice setup. I am also interested in your answers to Gary's questions. I'm assuming you've replaced the furling line with 6mm line. Could you please tell me the length of that 6mm line you were able to fit on the spool to reach back to the rear seat position? Thanks John |
Author: | jhawkman [ Tue Mar 21, 2017 2:38 pm ] |
Post subject: | Re: Better sail controls for both seats on 2015 TI |
Kleake, that is a great setup. I have contacted all the aftermarket people and Harken themselves and shown them your pictures but no one knows where your twin cam cleat mount/plate comes from! Can you tell us where you got it? Thanks. |
Author: | bluesman [ Sun Jun 03, 2018 4:45 am ] |
Post subject: | Re: Better sail controls for both seats on 2015 TI |
I was hoping to ressurect this post. I want to install a setup like this and I am not familiar with the rail setup. Can someone knowledgeable chime in and provide some direction. Are rails like this standard? Who makes them, what are they? |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |