| Hobie Forums http://www.hobie.com/forums/ |
|
| knot at rudder end for up control line? http://www.hobie.com/forums/viewtopic.php?f=70&t=69174 |
Page 1 of 1 |
| Author: | jennmckown [ Wed Oct 13, 2021 4:35 am ] |
| Post subject: | knot at rudder end for up control line? |
I understand how to run the new rudder up-line thru the hull but how does one tie off the end right at the rudder--do you have to take out that little metal pin? why is it such a tight fit there for that knot?? |
|
| Author: | incognito [ Fri Nov 05, 2021 5:14 pm ] |
| Post subject: | Re: knot at rudder end for up control line? |
I did take out the metal pin, pushed it out with a screw. then push the line far inside the rudder where it should be , then reinstaled the pin and did the knot |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|