Hobie Forums http://www.hobie.com/forums/ |
|
spacing for TI cradles http://www.hobie.com/forums/viewtopic.php?f=71&t=45416 |
Page 2 of 2 |
Author: | Tom Kirkman [ Sun Oct 28, 2012 2:55 pm ] |
Post subject: | Re: spacing for TI cradles |
Agreed. I put the cradles in the spots where they fit the hull/s. For storage, I may well add a foam block on the trailer somewhere just aft of the bow. |
Author: | stringy [ Sun Oct 28, 2012 3:53 pm ] |
Post subject: | Re: spacing for TI cradles |
Puget wrote: With 2 cradles the problem is not so much where the cradles are, but whether the bow and stern are supported. Puget Puget's point is a good one. The longer length of the TI requires bow and stern support. I had always had a bow support but I noticed hull deflection just aft of the rear cradle caused by an unsupported stern. After trialling blocks, rollers etc I found adding a third cradle at the stern to be the most effective. It supports the main hull stern in storage/transport but allows for much easier loading/unloading by supporting all of the TI's underhull when sliding it on/off. |
Author: | Tom Kirkman [ Sun Oct 28, 2012 4:53 pm ] |
Post subject: | Re: spacing for TI cradles |
Hurricane is on the way. Got to use the new TI today. http://www.youtube.com/watch?v=to3beqQDLk0 |
Page 2 of 2 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |