Hobie Forums
http://www.hobie.com/forums/

TeflonTrailer Slides in australia (Melbourne)
http://www.hobie.com/forums/viewtopic.php?f=73&t=32520		 Page 1 of 1
Author:  Paul67 [ Wed Oct 06, 2010 4:37 am ]
Post subject:  TeflonTrailer Slides in australia (Melbourne)
I am looking to buy a strip of teflon 'slider' to assist me in loading/unloading my TI. For what ever reason I can not seem to find a store (maybe I am looking in the wrong place).

Does anyone have any suggestions where to buy it?
Author:  ELM [ Wed Oct 06, 2010 6:20 am ]
Post subject:  Re: TeflonTrailer Slides in australia (Melbourne)
Try here; http://www.plasticfabricator.com.au/plastic+wear+strips+chain+guide.htm
Bayswater
http://www.vesco.com.au/hilube/index.php
Hallam
http://www.dotmar.com.au/contact-us.html
Branch in Dingley
http://www.plaspanel.com.au/contact.php
Airport West

If you have a Blackwoods store near you, they may be able to help, conveyor suppliers would have it. Doesn't it (censored) you, I was in a place only in the last few weeks and they had huge sheets of cutting board but for the life of me I cannot remember where :roll: :oops:

Best of luck and if I do remember I will be back, Hmm thats if I remember where I read this :roll: :lol:
Author:  stringy [ Wed Oct 06, 2010 1:25 pm ]
Post subject:  Re: TeflonTrailer Slides in australia (Melbourne)
Paul,
Any decent chandlery should have it.
BCF, BiasBoating and Whitworths all stock it.
Look for blue poly trailer strip (it's not really teflon). :)
Author:  angusisthedevil [ Wed Oct 06, 2010 7:41 pm ]
Post subject:  Re: TeflonTrailer Slides in australia (Melbourne)
We buy from Dotmar for work.

Usually buy polystone ultra (UHMW polyethelene) It is green.

If you want cheaper then there is also a recycled one available.

Cheaper than buying from a boat store for sure! You can but strips and fix it yourself rather than paying a premium for the word "boat" mentioned!
Author:  Paul67 [ Wed Oct 06, 2010 10:49 pm ]
Post subject:  Re: TeflonTrailer Slides in australia (Melbourne)
Thanks all from your advise.

regards Paul
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/