Hobie Forums
http://www.hobie.com/forums/

Daggerboard Separating
http://www.hobie.com/forums/viewtopic.php?f=75&t=37331
Page 1 of 1

Author:  onremlop [ Sat Aug 06, 2011 3:12 pm ]
Post subject:  Daggerboard Separating

My daggerboard is separating from the tip down about 4 or 5 inches. What is the best way to fix this? Is there some type of epoxy I should use? Any help would be appreciated.

Thx.

Author:  NOHUHU [ Mon Aug 08, 2011 1:39 pm ]
Post subject:  Re: Daggerboard Separating

G-Flex and fiberglass, I would guess.

http://www.westsystem.com/ss/g-flex-epoxy/

There are some videos at the West System site that may give you guidance.

I have the older fglass dagger. The newer ones are plastic, I believe, and may respond to heat sealing.

Author:  onremlop [ Mon Aug 08, 2011 5:39 pm ]
Post subject:  Re: Daggerboard Separating

Thanks, I'll check out West Marine.

Author:  NOHUHU [ Mon Mar 26, 2012 7:28 pm ]
Post subject:  Re: Daggerboard Separating

Any luck with the dagger repair?

I, um,.. er,... hem, need to do it too. :oops:

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/