Hobie Forums http://www.hobie.com/forums/ |
|
Is this normal? http://www.hobie.com/forums/viewtopic.php?f=75&t=44316 |
Page 1 of 1 |
Author: | biggrupr [ Mon Aug 06, 2012 8:16 pm ] |
Post subject: | Is this normal? |
I Just picked up my TI tonight and I noticed that the rear seat scuppers are not actually solid and don't necessarily line up with the tubes going down to below. It seems that this could lead to a problem with water not leaving the well, but rather entering the hull itself. |
Author: | augaug [ Mon Aug 06, 2012 9:00 pm ] |
Post subject: | Re: Is this normal? |
Should be fine. Those are protective sleeves that help prevent scupper cart damage. The old boats didn't have them. You're actually less at risk of a problem with your newer boat. I'm assuming that there is not a hole above the black part, but just a gap, if that's the case I wouldn't worry about things not lining up perfectly. That's pretty close, and from what I understand, the rotomolding process isn't an exact science. If it made it to the dealer, and to you, it's probably passed inspection, and is fine. If that were my boat, I wouldn't have a worry at all. |
Author: | tonystott [ Mon Aug 06, 2012 9:46 pm ] |
Post subject: | Re: Is this normal? |
Can you reduce the size of the photo by about a factor of four so it can been seen on a single screen? BTW, don't worry about the black bit, as augang said |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |