| Hobie Forums http://www.hobie.com/forums/ |
|
| 2012 TI "front hatch sealing gasket" part no http://www.hobie.com/forums/viewtopic.php?f=75&t=51393 |
Page 1 of 1 |
| Author: | serbi [ Mon May 26, 2014 3:14 am ] |
| Post subject: | 2012 TI "front hatch sealing gasket" part no |
I have a 2011 / 2012 (not exactly sure) TI and the rubber seals on the front hatch are damaged beyond repair. I remember from a previous very old post that Hobie changed the design of the rubber sealing cascets and want to order the replacement sealing gaskets. Does anybody know the part nos? ( I would need the part no for the "upper" seal of the front hatch (the "door" you open and close) and the "lower" seal going around the hull where the front hatch is closing. I assume the replacement seals (new design) fit into an older 2011 / 2012 TI hull? Any feedback is appreciated. Peace Serbi |
|
| Author: | serbi [ Mon May 26, 2014 3:34 am ] |
| Post subject: | Re: 2012 TI "front hatch sealing gasket" part no |
managed to download the 2013 Hobie catalogue. Are these the right part nos:? 71301001 HATCH SEAL "TRIM-LoC"....for the upper seal 71302001 HULL FLAngE SEAL (PRE 2012 ADV) Peace Serbi |
|
| Author: | mmiller [ Tue May 27, 2014 9:03 am ] |
| Post subject: | Re: 2012 TI "front hatch sealing gasket" part no |
71301001 HATCH SEAL "Trim-Loc" for both the hull and lid. |
|
| Author: | Sardinian Islander [ Fri Sep 09, 2016 3:03 pm ] |
| Post subject: | Re: 2012 TI "front hatch sealing gasket" part no |
old post i know. .. i have the same problem. have to change the seal. mine is 2011 do i need 71301001 HATCH SEAL "TRIM-LOC" (TOP MOLDED) 5’ REQ or 71302001 HULL FLANGE SEAL (PRE 2012 ADV) "TRIM-LOC" (SIDE GLUED) 5’ REQ thanx |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|