Ok, try this.
| Hobie Forums http://www.hobie.com/forums/ |
|
| Cross brace bracket broke off http://www.hobie.com/forums/viewtopic.php?f=75&t=61611 |
Page 1 of 1 |
| Author: | wunder [ Wed Sep 27, 2017 9:29 am ] |
| Post subject: | Cross brace bracket broke off |
Hi, one of my TI cross-brace holders snapped off. I tried to rivet it back in place, but the hole in the aka is too large. Any suggestions? I thought maybe I could use JBWeld, but I'd rather rivet it in place. https://drive.google.com/a/allprosoftwa ... sp=sharing |
|
| Author: | Tech [ Wed Sep 27, 2017 10:28 am ] |
| Post subject: | Re: Cross brace bracket broke off |
Cannot see picture. |
|
| Author: | wunder [ Wed Sep 27, 2017 11:41 am ] |
| Post subject: | Re: Cross brace bracket broke off |
Is it possible to upload a picture on the forums? |
|
| Author: | mmiller [ Wed Sep 27, 2017 11:57 am ] |
| Post subject: | Re: Cross brace bracket broke off |
Image posting FAQ:https://www.hobie.com/forums/viewtopic.php?f=21&t=12574 Hobie does not host images or files on our private servers due to liability and security issues. |
|
| Author: | wunder [ Wed Sep 27, 2017 12:49 pm ] |
| Post subject: | Re: Cross brace bracket broke off |
Ok, try this.
|
|
| Author: | mmiller [ Wed Sep 27, 2017 1:54 pm ] |
| Post subject: | Re: Cross brace bracket broke off |
Ahhh... not a critical part, so even a zip tie around the crossbar could hold this. I would replace the rivet or use a larger size (than the 3/16 rivet) screw possibly. |
|
| Author: | wunder [ Wed Sep 27, 2017 2:26 pm ] |
| Post subject: | Re: Cross brace bracket broke off |
Right not critical- just annoying to have the bar flopping around. Good idea on the zip tie- I'll give that a whirl. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|