Return to Hobie.com
Hobie Forums
It is currently Fri Feb 28, 2020 5:13 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Mon May 07, 2018 5:05 am 
Offline
Site Rank - Old Salt

Joined: Fri Mar 23, 2007 8:12 am
Posts: 441
Location: Florida
Have a 2012 Tandem Island with a cracked mast receiver. Want to be sure I have the right part - #7951401? It appears to have the mast retainer clip and spring already included is that correct? Also does the mast receiver assembly come with the step pin plate at the bottom or is this a separate item to purchase?

I am also considering replacing the mast base #79511101 as it looks a bit worn in the hole where it goes onto the step plate. I see that is is attached with 2 rivets which I'm sure I can drill out. However, how hard will this be to replace as I suspect there is a great deal of glue used in attaching the mast base to bottom of the mast. I don't want to risk mast damage having to hammer off the mast base. Any suggestions?

Thanks much -

Yakaholic


Top
 Profile  
 
PostPosted: Mon May 07, 2018 3:54 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 13239
Location: Oceanside, California
Check number... 79514101 includes the step pin installed.

Image

_________________
Matt Miller
Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA


Top
 Profile  
 
PostPosted: Mon Jun 03, 2019 6:33 am 
Offline
Site Rank - Deck Hand

Joined: Mon Jun 03, 2019 6:16 am
Posts: 3
I have an older mast receiver, it has a small metal plate attached to a pull string handle rather than the locking lever shown above . It doesn’t seemed to be locking to the mast anymore, and was wondering if the above shown part can be used as a replacement? And if so, would I need a new mast? Thanks in advance


Top
 Profile  
 
PostPosted: Mon Jun 03, 2019 8:04 am 
Offline
Hobie Tech / Moderator

Joined: Wed May 28, 2003 1:12 pm
Posts: 1396
Inkponder wrote:
I have an older mast receiver, it has a small metal plate attached to a pull string handle rather than the locking lever shown above . It doesn’t seemed to be locking to the mast anymore, and was wondering if the above shown part can be used as a replacement? And if so, would I need a new mast? Thanks in advance


Yes
79532001
SPRING ASSEMBLY, ISLAND ADV

US$ 7.59
Image


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group