Hobie Forums
http://www.hobie.com/forums/

2015 TI Mast rotate bearing material and diameter?
http://www.hobie.com/forums/viewtopic.php?f=75&t=65115
Page 1 of 1

Author:  UKTI [ Tue Jul 09, 2019 5:51 am ]
Post subject:  2015 TI Mast rotate bearing material and diameter?

Have just returned from a great offshore trip around The Lizard and Lands End. TI was great and I camped onboard under an awning.

Now have noticed that the mast bearings are still there, but most are in the mast well....

Suspect I will have to replace the bearings and the top and bottom keeper plates. I would like to carry a spare set of bearings.

Looks like they are Delryn, and the size is either 10mm, or, 3/8". Can anyone please confirm this?

Many Thanks

Author:  mmiller [ Tue Jul 23, 2019 10:12 am ]
Post subject:  Re: 2015 TI Mast rotate bearing material and diameter?

90610111 DELRIN BALL 3/8 DIA - FURLERS

24 required

90610112 DELRIN BALL 3/8 DIA (PKG OF 12)

Author:  tonystott [ Tue Jul 23, 2019 11:18 am ]
Post subject:  Re: 2015 TI Mast rotate bearing material and diameter?

While you have it apart to replace the bearings, it might be opportune to sand the mating plate faces with a rigid surface to eliminate any high-spots, thus reducing the possibility for future escape of delrin bslls

Author:  UKTI [ Wed Jul 24, 2019 2:46 am ]
Post subject:  Re: 2015 TI Mast rotate bearing material and diameter?

Many thanks to you both!

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/