Hobie Forums http://www.hobie.com/forums/ |
|
Papaya plastic http://www.hobie.com/forums/viewtopic.php?f=78&t=46688 |
Page 1 of 1 |
Author: | AllElectricPA14 [ Fri Mar 01, 2013 10:58 am ] |
Post subject: | Papaya plastic |
Is there any chance of getting some scrap Papaya plastic to use for welding? I would love to get cut outs from the hatch hole or whatever else Hobie normally just throws away. Of course, sometimes that stuff goes into regrind for reuse in molding. I have some holes to fill and a scar on the bottom that needs filling. |
Author: | mmiller [ Fri Mar 01, 2013 11:18 am ] |
Post subject: | Re: Papaya plastic |
Contact your dealer. They can get the material from the factory. We have cut-outs and welding rod stock. No Charge. |
Author: | AllElectricPA14 [ Fri Mar 01, 2013 11:31 am ] |
Post subject: | Re: Papaya plastic |
Thanks I will try that. We travel full time so we are all over the place and not in one spot too long so have no specific "dealer". |
Author: | AllElectricPA14 [ Thu Apr 18, 2013 8:33 am ] |
Post subject: | Re: Papaya plastic |
We have been in the Orlando area for a while now and I finally got a chance to go to my original Dealer, Travel Country in Altamonte Springs. Todd got me a nice cut out to use for hole filling. Great dealer and again thanks for the tip Mark. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |