Hobie Forums http://www.hobie.com/forums/ |
|
Install fish finder in new PA12 http://www.hobie.com/forums/viewtopic.php?f=78&t=47507 |
Page 1 of 1 |
Author: | Powbass [ Wed May 08, 2013 6:51 am ] |
Post subject: | Install fish finder in new PA12 |
Have the cables installed. Can t get the foam blocks back to orignal position. Any tricks to reinstalling The foam blocks. |
Author: | tpmister [ Wed May 08, 2013 12:02 pm ] |
Post subject: | Re: Install fish finder in new PA12 |
You just have to force them in there...they have to compress a bit. So push them until they go. But be sure they are not interfering (touching) any of the cordage that runs behind the blocks (steering & rudder). |
Author: | islandspeed2001 [ Wed May 08, 2013 1:21 pm ] |
Post subject: | Re: Install fish finder in new PA12 |
Tip the top of the blocks back into where they fit. Then force the bottom of the foam blocks back. It's not going to destroy the foam. |
Author: | Powbass [ Wed May 08, 2013 4:18 pm ] |
Post subject: | Re: Install fish finder in new PA12 |
problem solved::: trick was to tip the top toward the middle of boat and pull the bottom of the block into upright position. Thanks |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |