After fishing today, I went to remove the mirage drive. However, It would not come out. It appeared to be hung up under neath the hull. After inspecting, It appeared the main 1/2" shaft or axle had worked its way to one side and was hanging out by inch, which was hanging on the bottom of the hull. After tapping on it, It moved back into place. My questing is, this set up does not seem too reliable if this continues on a regular bases . Any of you ever experience this issue? Or is it jush as simple as tightening a set screw, pin, clip, etc.. Btw.. I do have a call into ACK . Keep in mind this has on seen only 3-4 outings. I hope Hobie has a solution.
|