Hobie Forums
http://www.hobie.com/forums/

PA14 Dash Board help
http://www.hobie.com/forums/viewtopic.php?f=78&t=48190
Page 1 of 1

Author:  Cudadude [ Wed Jun 26, 2013 6:42 am ]
Post subject:  PA14 Dash Board help

I’m not sure if this has been asked before. I’m looking to do some mods to my PA14.
What I’m looking for is a Plastic supplier for the Dash boards. All I really need is a blank to be cut out.
My plans are to redesign a dash board to hang over the edge on both sides to add lights to shine downward, and make my own design of holder cutouts for fishing gear, Without the need to drill into the body of the craft.
Thanks in advance for your help. Joe

Author:  Pete@JAX [ Wed Jun 26, 2013 6:55 am ]
Post subject:  Re: PA14 Dash Board help

West Marine -- Starboard

or

http://www.interstateplastics.com/searc ... 7Aod0l8AYg

Author:  Cudadude [ Wed Jun 26, 2013 7:23 am ]
Post subject:  Re: PA14 Dash Board help

Perfect, Thx Pete

Author:  Jude [ Thu Jun 27, 2013 2:01 am ]
Post subject:  Re: PA14 Dash Board help

They make lights that go under the hull as well...

Author:  Pete@JAX [ Thu Jun 27, 2013 3:18 am ]
Post subject:  Re: PA14 Dash Board help

This is a good solution - http://www.youtube.com/watch?v=DVFgiXdvUJg

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/