PA14 Hatch Sealing

How do you guys seal your front hatch better on a PA14. I get a little water in the hull and in the liner from boat wakes and rain. The liner does not fit in the hatch right and leaves a gap in each rear corner.

_________________
2014 PA14
Proud Volunteer Guide for Heroes on the Water NJ

Addressed many times. Search it in this forum most people upgrade the seal to a bigger rubber

I searched found one that was for the older models and it went off topic a page in. Just wondering if there was a more recent post.

_________________
2014 PA14
Proud Volunteer Guide for Heroes on the Water NJ

https://www.youtube.com/watch?v=1epb7IZhnyE

Here is how we did it. Some 1/2 polyethylene foam, spray glue and Voila, it's sealed. The extra thickness of the foam compresses the tub deeper in to the weather strip AND insulates the tub. We then went even further and insulated the tub itself. It makes a pretty good cooler and I'm in Florida sun!

See that here: https://www.youtube.com/watch?v=K9RCZNrchbw

Hope it helps!