Return to Hobie.com
Hobie Forums
It is currently Thu Mar 28, 2024 12:14 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Fri Dec 29, 2017 11:31 am 
Offline
Site Rank - Deck Hand

Joined: Sun Jul 17, 2011 6:38 pm
Posts: 20
Hi All,

I’m gonna sell my 2012 PA 14 and removed all of the components for my evolve (I have 2 revos that I’ll use it on). I was able to use the plug cover for the motor cable to seal the hole it left in the hull. However, I’m struggling about what to use to cover the three holes (cable & screw holes) from the vacant throttle cable. I can’t seem to find a piece to use that covers everything. The few options I have tried all have different patterns which require more holes that are so close to the existing ones that it would compromise it more. I’d leave the existing fitting in there, but it has the entire cable attached to it.

Any ideas or experience? The throttle cable hole is next to the seat so it’s not like it would sink, I’d like to sell it as a sealed hull.

Thanks.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group