Hobie Forums
http://www.hobie.com/forums/

Sealing through hull spots after removing Evolve
http://www.hobie.com/forums/viewtopic.php?f=78&t=61975
Page 1 of 1

Author:  Dive-n-Cast [ Fri Dec 29, 2017 11:31 am ]
Post subject:  Sealing through hull spots after removing Evolve

Hi All,

I’m gonna sell my 2012 PA 14 and removed all of the components for my evolve (I have 2 revos that I’ll use it on). I was able to use the plug cover for the motor cable to seal the hole it left in the hull. However, I’m struggling about what to use to cover the three holes (cable & screw holes) from the vacant throttle cable. I can’t seem to find a piece to use that covers everything. The few options I have tried all have different patterns which require more holes that are so close to the existing ones that it would compromise it more. I’d leave the existing fitting in there, but it has the entire cable attached to it.

Any ideas or experience? The throttle cable hole is next to the seat so it’s not like it would sink, I’d like to sell it as a sealed hull.

Thanks.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/