Return to Hobie.com
Hobie Forums
It is currently Thu Mar 28, 2024 1:42 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: JetSki/ProAngler lift
PostPosted: Sun Mar 25, 2018 8:16 am 
Offline
Site Rank - Deck Hand

Joined: Fri Mar 11, 2016 12:03 pm
Posts: 13
On my boat dock I have my ProAngler 14 and would like to add a new PWC /JetSki. Now my ProAngler rests on the Hobie cradles and the motorized lift lifts it up and down into the water. Ideally my new PWC will sit right beside my Hobie so either can be lifted in and out of the water. The problem I foresee is that when lowering either craft the other craft will start floating away. As an example if I lower my lift to take out the PWC the Hobie will also be floating and could float away. If I secure either and someone lowers the lift too far it will submerge the other craft.
Any suggestions would be appreciated.


Top
 Profile  
 
PostPosted: Mon Jun 18, 2018 11:24 am 
Offline
Site Rank - Deck Hand

Joined: Wed Jul 16, 2014 11:17 am
Posts: 3
This reply may be to late. I just had a new dock built. I have a Solo Skiff and Gheenoe set up the way you are describing. Don't float the boats. Put them in far enough that you can push and pull the boats on and off the lift fairly easy.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group