Return to Hobie.com
Hobie Forums
It is currently Mon Dec 09, 2019 8:54 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sat Jul 06, 2019 7:50 pm 
Offline
Site Rank - Deck Hand

Joined: Fri Jan 18, 2019 9:54 am
Posts: 2
I just brought a use PA 12. one side of the control is straight and line up with rudder, but the left side arm is not straight. So something is wrong with the left arm, I need to know how to move the pin. How to fix this? I try to loosen the rudder line as suggested by other members, and it did not fix the problem. Looking at the steering line diagram, I need to loosen the upper loop that attach to the left arm and straight up the left arm and re-attach the line. This is easy say than done, hobie did not design this for easy access to this line. So I am stuck, any suggestions to fix this will be greatly appreciated. I don't know how to attach image.


Top
 Profile  
 
PostPosted: Wed Jul 17, 2019 10:44 pm 
Offline
Site Rank - Old Salt

Joined: Sat Sep 20, 2008 8:19 am
Posts: 354
Location: Australia
It sounds like the line connecting the left and right steering handles is a little loose, which results in poor calibration between the two handles. Remove the line from the right steering handle (pull the loop off the post on the crank) and tie a knot in the line to reduce it's length and see if that makes a difference.

_________________
Kayak Fishing Specialist: SLH
https://slhobie.com.au


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group