Hobie Forums
http://www.hobie.com/forums/

Potential Hull deformity? - question for Matt Miller
http://www.hobie.com/forums/viewtopic.php?f=78&t=67205
Page 1 of 1

Author:  russeak [ Mon Aug 17, 2020 2:27 pm ]
Post subject:  Potential Hull deformity? - question for Matt Miller

Hi Matt-
I recently bought a used PA360 and I'm noticing that the port side of the bow has a slight "slant". Doesn't seem to any difference in the boat's molding below the waterline but a slight slant is definitely evident when you look and bow grab handle. I haven't noticed any impact on the water. Something I should be concerned about? Once I figure out how to post images I will.

Russ

Author:  mmiller [ Wed Aug 26, 2020 11:02 am ]
Post subject:  Re: Potential Hull deformity? - question for Matt Miller

Would not be a functional issue. Boats are hand shaped and molds distort over time. Boats vary as they come out of the molds too. Different colors vary.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/