Hobie Forums http://www.hobie.com/forums/ |
|
Rudder Drilling Template http://www.hobie.com/forums/viewtopic.php?f=9&t=64452 |
Page 1 of 1 |
Author: | Tom Kirkman [ Wed Mar 27, 2019 8:11 am ] |
Post subject: | Rudder Drilling Template |
The available Hobie Rudder Drilling Template does not contain information for drilling the EPO3 Rudder, which has a different profile than the other Hobie cat rudder blades. Attempting to install an EPO3 on a FX One - Tiger upper and lower castings. Anyone have a drilling guide for this? Thanks. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |