Hobie Forums http://www.hobie.com/forums/ |
|
Rudder locking kit problem http://www.hobie.com/forums/viewtopic.php?f=9&t=66686 |
Page 1 of 1 |
Author: | Bobb-is [ Wed Jun 10, 2020 8:58 am ] |
Post subject: | Rudder locking kit problem |
I'm refurbishing an old 78 cat 16. the Delrin screw is breaking apart when trying to unscrew to appoint where I cannot free it. any suggestions on how to clear this out so I can replace the kit and the cam? |
Author: | srm [ Thu Jun 11, 2020 4:46 pm ] |
Post subject: | Re: Rudder locking kit problem |
Very common. The screw is 3/4”-10. Use a 5/8” drill to drill out the plastic screw without damaging the threads in the casting. Then you can use a 3/4”-10 bolt or piece of threaded rod with a groove cut in the end to clear out the remaining plastic from the casting. When installing the new screw, coat the threads with grease to prevent seizing. sm |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |