Return to Hobie.com
Hobie Forums
It is currently Thu Mar 28, 2024 1:47 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Mon Jul 20, 2020 7:39 am 
Offline
Site Rank - Deck Hand

Joined: Mon Jul 20, 2020 7:29 am
Posts: 2
Location: Encinitas, California
I recently purchased an old Holder 12. It looks like it is missing the upper rudder pin clip as there is nothing to prevent the rudder from lifting out of the fittings on the transom. Anyone know what this part looks like or if it is still available? The assembly manual mentions the clip but the picture is too blurry to make it out.
Thanks,
Rob


Top
 Profile  
 
PostPosted: Mon Jul 20, 2020 9:35 am 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 15027
Location: Oceanside, California
Not available. It was a spring plate attached to the pintle.

You could drill and install keeper wire or something.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)


Top
 Profile  
 
PostPosted: Tue Oct 06, 2020 6:58 am 
Offline
Site Rank - Deck Hand

Joined: Mon Jul 20, 2020 7:29 am
Posts: 2
Location: Encinitas, California
mmiller wrote:
Not available. It was a spring plate attached to the pintle.

You could drill and install keeper wire or something.


Thanks Mike. I ended up using a simple spring cotter pin which works great


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group