Return to Hobie.com
Hobie Forums
It is currently Fri Mar 29, 2024 4:41 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Wed May 08, 2013 6:51 am 
Offline
Site Rank - Deck Hand

Joined: Sun May 05, 2013 7:10 am
Posts: 23
Have the cables installed. Can t get the foam blocks back to orignal position. Any tricks to reinstalling
The foam blocks.


Top
 Profile  
 
PostPosted: Wed May 08, 2013 12:02 pm 
Offline
Site Rank - Captain

Joined: Wed Jul 25, 2012 6:05 pm
Posts: 49
You just have to force them in there...they have to compress a bit. So push them until they go.

But be sure they are not interfering (touching) any of the cordage that runs behind the blocks (steering & rudder).


Top
 Profile  
 
PostPosted: Wed May 08, 2013 1:21 pm 
Offline
Site Rank - Old Salt

Joined: Mon Apr 26, 2010 6:06 am
Posts: 734
Location: Amelia Island, FL
Tip the top of the blocks back into where they fit. Then force the bottom of the foam blocks back. It's not going to destroy the foam.


Top
 Profile  
 
PostPosted: Wed May 08, 2013 4:18 pm 
Offline
Site Rank - Deck Hand

Joined: Sun May 05, 2013 7:10 am
Posts: 23
problem solved::: trick was to tip the top toward the middle of boat and pull the bottom of the block into upright position. Thanks


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group