Jose Javier wrote:
thanks
I understand what you tell myself but I need to know that type of inject laminating resin use?, because in my country venezuela, I dont have many options? the git rot no found.
I can use the resin of fiberglass?
this tecnica can be used if the area is big?
excuses my badly english.
Gracias
Yo entiendo lo que tu me quieres decir, pero necesito conocer que tipo de recina puedo usar, porque en venezuela no tengo mucha variedad, el producto git rot no lo consigo.
Yo puedo usar la resida de la fibra de vidrio?
Puedo usar esta tecnica para un area grande?
Gracias, mi español si esta bien, creo?
¡Ha! Si, mejor que lo mio.
¿Puedes comprar el Git Rot en el internet o no? Yo creo que el Git Rot esta bien porque esta muy (delgada?) y por eso puede entrar en todos los poros de la espuma. (¡Ay! ¿Me entiendes?) Si no puedes comprar Git Rot, creo que puedes usar el West System epoxy con el 105 Resin y 206 slow hardener (por que es endurecedor de poca viscosidad. (?))
Pienso que este combinacion puede ser casi lo mismo (de el Git Rot), pero yo no soy experto de epoxy y probablamente hay otras personas que te pueden enseñar mejor que yo.
---------------------------------------
(In English) Can you buy Git Rot on the internet? I think it's supposed to be good for this because it's a very thin epoxy and because of this it can get through all the pores of the foam. If you can't get Git Rot, I think you could probably use the West System epoxy with 105 resin and 206 Slow Hardener because it's low viscosity.
I think this combination could be the same as the Git Rot, but I'm not an epoxy expert and I'm sure there are other people that can tell you better than I.
Regards,
Jim