Return to Hobie.com
Hobie Forums
It is currently Fri Jul 18, 2025 4:18 pm

Board index » Hobie Kayaking / Fishing » Open Forum - Kayaking

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
kayakangle
PostPosted: Thu Jul 15, 2010 8:00 pm 
Offline
Site Rank - Deck Hand

Joined: Sun Jun 01, 2008 8:07 am
Posts: 8
Can anyone tell me what the outside diameter of the crossbar is that fits the Side Kick Outrigger mounts?

Thanks!
Top
 Profile  
 
stringy
PostPosted: Fri Jul 16, 2010 8:21 pm 
Offline
Site Rank - Old Salt

Joined: Thu Aug 16, 2007 2:25 pm
Posts: 2866
Location: Central Coast NSW Australia
It's the same OD as the paddle shafts.
29.5mm according to my metric calipers. :)
Top
 Profile  
 
kayakangle
PostPosted: Sat Jul 17, 2010 6:02 am 
Offline
Site Rank - Deck Hand

Joined: Sun Jun 01, 2008 8:07 am
Posts: 8
Thanks Stringy! I'm building a bar mount using the sidekick crossbar mounts so. Not very good at converting metric to inches but I'm assuming that I need to use 1 1/8 inch OD round bar?
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Hobie Kayaking / Fishing » Open Forum - Kayaking

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group