Return to Hobie.com
Hobie Forums
It is currently Fri Jul 18, 2025 10:15 am

Board index » Hobie Kayaking / Fishing » Open Forum - Kayaking

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Skadar
PostPosted: Tue Jun 28, 2011 8:57 am 
Offline
Site Rank - Captain

Joined: Tue Aug 11, 2009 7:41 am
Posts: 72
Location: Stamford, CT
Are Hobies metric or standard in general?

In particular, what size hex wrench is use in the Mirage drive clamp (Click and Go) assembly. I noticed that one of my assemblies is a little loose. I can see hex nuts down through the holes, but I want to make sure I use the correct wrench size to avoid stripping when I tighten it up.

Thanks!
Top
 Profile  
 
EuroKayaker
PostPosted: Wed Jun 29, 2011 2:34 am 
Offline
Site Rank - Captain

Joined: Tue Feb 15, 2011 3:19 am
Posts: 58
Location: The Netherlands
requires 3/16" allen "ball" wrench
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Hobie Kayaking / Fishing » Open Forum - Kayaking

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group