Return to Hobie.com
Hobie Forums
It is currently Wed Sep 10, 2025 9:10 am

Board index » Hobie Catamaran Sailing » Hobie 16

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
italianhobie
 Post subject: main beam
PostPosted: Thu May 31, 2007 3:54 am 
Offline
Site Rank - Captain

Joined: Fri Jul 29, 2005 11:54 am
Posts: 57
hi to all

just one question...
how much i must thight the dolphin striker?
can u post me the measure beetween the front fusion where the ds is bolted?

thanx a lot

max
Top
 Profile  
 
MBounds
 Post subject:
PostPosted: Thu May 31, 2007 4:11 am 
Offline
Hobie Approved Guru

Joined: Mon Jul 14, 2003 7:11 pm
Posts: 5198
Location: Detroit, MI
The dolphin striker should be tightened until it sounds like "thrummmm" when you hit it with your hand.

If it goes "clunk", it's too loose.

There no real measurement to be made. You tighten it until it is . . tight.

I'm not sure what you mean by "the front fusion"
Top
 Profile  
 
italianhobie
 Post subject:
PostPosted: Thu May 31, 2007 6:26 am 
Offline
Site Rank - Captain

Joined: Fri Jul 29, 2005 11:54 am
Posts: 57
i mean the fron corner....
to tight mine i have measured the distance between the front corner on mine and over another h16 more new, were the dolphin striker enter and tight mine to achieve about the same distance
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Hobie Catamaran Sailing » Hobie 16

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
cron
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group