Hull support on short station

I am reconfiguring a shore station to accept my H16, by supporting it with two transverse 2x6 covered in carpet (new 2x6 distributes load better than existing 2x4 aluminum extrusion tubes).

I would be grateful for any advice for locations of the 2x6s to best support the load. Please consider referencing this image with enumerated bulkheads. Any other related advice is welcomed!

[img]https://live.staticflickr.com/65535/55196201469_c2b9463c77_m.jpg[/img]

Image didn't show in preview:?: Please advise if this is bungled up.

I can’t see the picture that you posted. But if the 2x6’s are being oriented horizontally across the width of the boat, then the best spacing would probably to have them located directly below the pylon posts. This would help to transfer the weight of the boat and anyone standing on the trampoline directly through the trampoline frame and to the ground with minimal stress on the hulls.

sm