Corner Bolts

Page 1 of 1

[ 3 posts ]

Print view

Previous topic | Next topic

Author

Message

italianhobie

Post subject: Corner Bolts

Posted: Mon Mar 24, 2008 12:21 pm

Site Rank - Captain

Joined: Fri Jul 29, 2005 11:54 am
Posts: 57

Hi to all,

i have just buyed a 02 h16 i have noticed that the bolts used to keep the corner casting over the pilons are made in white plastic....
Over my 86 boat they was made in stainless steel.
Is it normal?

Thanx a lot
Max

Top

MBounds

Post subject:

Posted: Mon Mar 24, 2008 1:26 pm

Hobie Approved Guru

Joined: Mon Jul 14, 2003 7:11 pm
Posts: 5198
Location: Detroit, MI

That is normal.

The bolts are not under tension, so there is no stress on the plastic nuts.

Top

swampcreek

Post subject:

Posted: Tue Mar 25, 2008 6:50 am

Site Rank - Admiral

Joined: Thu Jul 13, 2006 7:03 am
Posts: 165
Location: Pasadena Md

Yeah! Thanks to this site I avoided a fatal error! When I first started refitting my 1981 H16 I noticed that 1 of the 4 original nylon nuts was missing and all the others were loose. So I found 4 stainless steel nuts in my "magic parts box" and snugged everything up real tight! I then read on this site that overtightening these nuts will crack your castings! So I ran down to the garage, removed the nuts, applied locktight and GENTLY snugged them back on. Another save by the knowledge on this site!

_________________
1981 H16.
1993 Macgregor 26S

Top

Page 1 of 1

[ 3 posts ]

Board index » Hobie Catamaran Sailing » Hobie 16

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to: