Return to Hobie.com
Hobie Forums
It is currently Thu May 01, 2025 6:33 am

Board index » Hobie Kayaking / Fishing » Hobie Mirage Outback

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
YakinEngineer
 Post subject: Pin Holes
PostPosted: Tue May 07, 2019 1:11 pm 
Offline
Site Rank - Deck Hand

Joined: Sat May 04, 2019 5:28 pm
Posts: 1
I discovered some pin holes on the seam of the my outback hull (see attached photos). Has anybody else discovered these, if so is it a cause for concern?

Image

Image

Image

_________________
_______________________________

Thanks,

AB
Top
 Profile  
 
mmiller
 Post subject: Re: Pin Holes
PostPosted: Tue May 07, 2019 3:55 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 15081
Location: Oceanside, California
That is along the mold parting line and is due to heat escaping during molding, but these are not pin holes. These are exposed tiny bubbles in the plastic that do not go thorough to the inside.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Hobie Kayaking / Fishing » Hobie Mirage Outback

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group