Hobie 21 taper pins

I have a problem with a hobie 21. The holes in the crossbeams, through which the taper pins pass, have become large and corroded. The taper pins are rendered ineffective, which allows a lot of play between the hulls and the crossbeams.

Any suggestions on a good fix for this will be much appreciated

If you can get us some pictures I will try to help you out. What year is the boat?


Thanks,
Brad Stephens
www.sunjammers.com<------New Site!
Authorized Hobie/Vanguard Dealer
Division 15 Chairman
Panama City Beach, FL
[email protected]
850-235-2281

I also had this issue, good old wear and tear. Check the inside diameter of the holes and have a machine shop turn some pins for you. Make sure you allow enough threads to tighten the taper pins.

I have a '88 21SE and am familiar with the pins. I think having those pins made, especially from stainless would cost $500+. I would suggest cleaning out the holes and welding them back smaller then re-bore to the correct size. You will probably have to remove the sleeves to avoid heat damage but they are easy to rivet back on if you remove them carefully.