Hobie Wave, JIB SHEET CLEAT WELL NUTS TO REMOUNT ?

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

zimmerj

Post subject: Hobie Wave, JIB SHEET CLEAT WELL NUTS TO REMOUNT ?

Posted: Tue Mar 03, 2026 12:59 pm

Site Rank - Deck Hand

Joined: Tue Mar 03, 2026 9:31 am
Posts: 1

(Admin edits... this is a Hobie Wave. If there are tracks that the trampoline attaches to the hull (Looks like it)... it would be a Club version)

I have a Older Hobie Wave, and just recently the jib sheet cleat broke off the the hull... Looks like original well nuts corroded. So I am looking on advice to replace ( Rubber Well Nuts or Thread Brass Inserts ) and any tips on sizes before I go drilling an poking around.

Top

mmiller

Post subject: Re: Hobie Wave, JIB SHEET CLEAT WELL NUTS TO REMOUNT ?

Posted: Wed Mar 04, 2026 12:05 am

Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 15097
Location: Oceanside, California

Installing a small deck port in the deck above this area would allow thru bolts and backing washers/nuts. That would be solid. drill through the remaining molded-in insert. I suspect it is aluminum if it corroded.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)

Top

Page 1 of 1

[ 2 posts ]

Board index » Hobie Catamaran Sailing » Help with repairs

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to: