Seals around tackle storage and front storage compartments

I have a 2010 Hobie Pro Angler 14 and the two black rubber seals around the tackle storage compartment and the front storage compartment just fold or fall odd. Is there an adhesive anyone can recommend to attach these?

Also I saw a gentleman who had raised seat, almost like you’d see on a bass boat but a shorter post. He was going in the opposite direction so I couldn’t catch him to ask where he picked it up. Anybody seen anything like that. This guy also had some gadget that seem like could roll them out to the side as pontoons. Again, where would I find these.

Thanks

Dave

Super glue works.

If you need new gaskets: Pro angler 14 bow hatch/lid 84-1/2"

New material is molded as a single part. No longer glued.

71305001 TRIM LOK SEAL (LG TOP-MOLDED)

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)

Matt - that's awesome. Thanks for the timely response. And just to be totally sure - this fits the older pre-2013 and the newer ones? I have a 2011.

Thanks again

Dave

Matt - thank you for the timely reply. Will this fit both the tackle stowaway cover in front of seat and the big cover in the front? I’ve got a 2011 Pro Angler..

Thanks again,

Dave

This is the big bulb... yes for forward hatch.

For the tackle hatch I would get the smaller one I think.

71301001 TRIM LOK SEAL (TOP MOLDED) Same look smaller seal.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)